Solarcharging Max 180watts

LLE

Hi I have to zendure solar 400w bags and plugged them in the sbv. But I only get 180 maximum. Is there a limit?
If I connect the satellite with the sbv they are charging with another 180-220 watts. In total I am at 600 watts. But I want full power in the station.
Tried serial and parallel configuration

DanielRolle

Same here, after recent update it started to count up to 275 and then jumped to 180 and hovered around that all day … being exposed fully to the sun

jonathanuwguy

Yes. I concur. Something is serious wrong with the latest DC firmware update 1.1.6. Right before

jonathanuwguy

Right before the update, it was showing 1.2kW For solar input and now it's capped at 250w. This is seriously bad. Zendure support, how can we roll back the firmware?

soe.ke1@mac.com

Same here [Suck] the Solar-charging is around 150 Watt, while there is enough Sun for 1000 Watt input.

henrideath

Hi gents same boat here did you get any update?

soe.ke1@mac.com

I asked Support in 27.06.2023 and reminded on 03.07.2023 with no response. Very frustrating…

soe.ke1@mac.com

New DC Update v1.1.6 today, Not updated yet

soe.ke1@mac.com

After installing the update, charging is „ back to normal

soe.ke1@mac.com

after installing the DC Update v1.1.6 from 13/14 July 2023, I thought the solar charging works correctly again. However, today I notice that despite perfect sunlight, the charging process is throttled again at about 50% battery charge to about 180 watts, although 1000 watts would be possible.

soe.ke1@mac.com

Have to correct, it‘s v1.1.7

tcrackz

[unknown]danke Johnie, den beitrag kenne ich. allerdings beantwortet er meine frage nicht. packData kommt allenthalben raus, meist mit Infos über Serialnumber, solar output, home power output etc. Meine Frage ist wann Spannungsdaten übertragen werden. Es geschieht nicht nach request-response. sondern man ‚abonniert‘ eine MQTT topic.