Hello everyone,
I've just received a second Hyper 2000.
I managed to get a cluster created but the new Hyper stays in stand by mode.
I've tried to delete the cluster and recreate it.
I've tried to use the new Hyper in standalone mode but it also stays in stand-by (even with a manual output or driven by the Shelly).
I plugged all the câble off, restart. I tried a reset, connect to wifi again but nothing works.
The last thing i did was to start the hyper without a battery. After let say 20 seconds, i can hear a ''click'' and after that i get a blinking red light (right side).
I run out of solution.
Can somebody help me ?
Thanks in advance.
Best regards.
Mathieu